Mark LT 2WD V8-5.4L VIN 5 (2007)
Part 2
Exploded View
Removal and Installation
1. Remove the rear door trim panel.
2. Position the watershield aside.
3. Open the clip and disconnect the exterior rear door handle actuating rod.
4. Remove the 2 exterior rear door handle nuts.
-
To install, tighten to 7 Nm (62 lb-in).
5. Remove the 2 exterior rear door handle seals.
6. Remove the 2 exterior rear door handle bolts.
-
To install, tighten to 7 Nm (62 lb-in).
7. Remove the exterior rear door handle.
8. To install, reverse the removal procedure.