Mark LT 2WD V8-5.4L VIN 5 (2007)
could result in pretensioner or air bag deployment and could result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a supplemental restraints system (SRS) component is being serviced, SRS must be depowered.
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Driver seat shown, passenger seat similar.
All seats
1. Remove the front seat and depower the SRS.
2. Remove the front seat backrest.
3. Push the 2 release tabs and remove the head restraint.
Seats with seat integrated restraints (SIR)
4. Remove the safety belt tower cover.
-
Remove the 2 covers, 4 screws and the safety belt tower cover.
All seats
5. Lift the material and release the backrest J-clip.
6. CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
seat backrest foam pad.
Separate the hook-and-loop fasteners and remove the hog rings on the front of the backrest foam pad.
Seats with map pockets
