Mark LT 2WD V8-5.4L VIN 5 (2007)
10. Disconnect the safety belt buckle switch electrical connector.
11. If equipped, disconnect the heat element electrical connector.
Seats with seat integrated restraints (SIR)
12. Remove the safety belt anchor nut.
-
To install, tighten to 55 Nm (41 lb-ft).
All seats
13. If equipped, disconnect the power seat track motor electrical connector and release any pin-type retainers attached to the seat cushion pan.
14. If equipped, disconnect the 3 memory seat motor position sensors (one shown) electrical connectors and release any pin-type retainers attached to
the seat cushion pan.
15. NOTE: Disconnect and release any remaining electrical connectors and pin-type retainers attached to the seat cushion and pan assembly.
Remove the 4 nuts and the seat cushion and pan assembly.
-
To install, tighten to 25 Nm (18 lb-ft).
