Mark LT 2WD V8-5.4L VIN 5 (2007)
4. Disconnect the electronic clutch electrical connector.
5. Remove the nut and the electronic cooling fan clutch wiring harness support bracket from the stud bolt.
^
To install, tighten to 13 Nm (10 ft. lbs.).
Vehicles equipped with a 5.4L (3V) engine.
6. Remove the air cleaner intake pipe.
7. REmove the bolts and the air cleaner intake pipe support bracket.
^
To install, tighten to 10 Nm (89 inch lbs.).
Vehicles equipped with a 4.2L engine
8. Using the special tools, remove the cooling fan assembly and position it in the fan shroud.
^
To install, tighten to 55 Nm (41 ft. lbs.).