Mark LT 2WD V8-5.4L VIN 5 (2007)
6. If equipped, connect the vacuum tube.
7. Position the crankcase ventilation tube and connect the quick connect couplings.
8. Using new O-rings, connect the evaporator inlet tube fitting.
9. Install the suction accumulator-to-A/C compressor manifold tube stud.
^
Tighten to 8 Nm (71 inch lbs.).
10. Lubricate the new A/C compressor manifold tube O-ring seals with refrigerant compressor oil. Position the A/C compressor manifold tube and
install the nut.
^
Tighten to 25 Nm (18 ft. lbs.).
11. Install the RH ignition coils.
12. Install the RH VCT oil control solenoid.
13. Install the PCM bracket and the PCM.
14. Evacuate, leak test and charge the refrigerant system.
