Mark LT 2WD V8-5.4L VIN 5 (2007)
7. CAUTION: Make sure the RH engine support insulator mating surfaces and the washer mating surface are free of foreign material and corrosion
before installation. Install a new washer.
CAUTION: Only use hand tools when installing the RH engine mount nuts or damage to the engine mount can occur.
Apply Threadlock 262 to the stud threads and install the RH engine support insulator washer and nuts.
^
Tighten to 250 Nm (184 ft. lbs.).
LH engine support insulator
8. If installing the LH engine support insulator in a 4WD vehicle, align the front driveshaft flange to the front axle pinion flange at the index mark
and install the bolts.
^
Tighten to 111 Nm (82 ft. lbs.).
9. Install the oil level indicator and tube.
RH engine support insulator
10. Install the starter.
All vehicles
11. Tighten the transmission mount nuts.
^
Tighten to 103 Nm (76 ft. lbs.).
12. Install the exhaust system support bracket bolts to the crossmember.
^
Tighten to 40 Nm (30 ft. lbs.).
