Mark LT 2WD V8-5.4L VIN 5 (2007)
2. NOTE: If the rear crankshaft seal retaining plate is not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with
silicone gasket remover and metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4
minutes, whichever is longer. Failure to follow this procedure can cause future oil leaks.
NOTE: The silicone must be applied on the groove along the retainer plate.
Apply a 4.06 mm (0.16 inch) bead of silicone gasket and sealant around the crankshaft rear seal retainer plate sealing surface.
3. Install the crankshaft rear seal retainer plate and the 6 bolts in the sequence shown.
^
Tighten to 10 Nm (89 inch lbs.).
4. NOTE: Lubricate the inner lip of the crankshaft rear seal with clean engine oil.
Using the special tools, install a new crankshaft rear seal.
5. Using the special tools, install a new crankshaft rear oil slinger.
