Mark LT 2WD V8-5.4L VIN 5 (2007)
Air Bag Deactivation Indicator: Service and Repair
PASSENGER AIR BAG DEACTIVATION (PAD) INDICATOR
Passenger Air Bag Deactivation (PAD) Indicator
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the system.
2. Remove the instrument panel center finish panel.
3. Disconnect the passenger air bag deactivation (PAD) indicator electrical connector.
4. Remove the PAD indicator screws and PAD indicator.
5. To install, reverse the removal procedure.
6. Repower the system.