Mark LT 2WD V8-5.4L VIN 5 (2007)
CAUTION: Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled
with clean, specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
NOTE: When any part of the hydraulic system has been disconnected for repair or new installation, air may get into the system and cause spongy brake
pedal action. This requires bleeding of the hydraulic system after it has been correctly connected. The hydraulic system can be gravity bled, manually
bled or bled with pressure bleeding equipment.
NOTE: When a new brake master cylinder has been installed or the system has been emptied or partially emptied, it should be primed to prevent air
from getting into the system.
1. Fill the brake master cylinder reservoir with clean, specified brake fluid.
2. Connect a clear hose to the RH rear disc brake caliper bleeder screw and place the other end into a container partially filled with clean, specified
brake fluid.
3. Open the bleeder screw and leave it open until clear, bubble-free brake fluid flows.
^
Refill the brake master cylinder reservoir as necessary.
4. Tighten the disc brake caliper bleeder screw.
^
Tighten to 20 Nm (15 ft. lbs.).
5. Repeat Steps 1 through 4 for the 3 remaining brake calipers, going in order from the LH rear disc brake caliper to the RH front disc brake caliper
and ending with the LH front disc brake caliper.
6. If the brake pedal feels spongy, repeat the bleed procedure.
Manual Bleeding
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will
render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
CAUTION: Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled
with clean, specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
NOTE: When any part of the hydraulic system has been disconnected for repair or new installation, air may get into the system and cause spongy brake
pedal action. This requires bleeding of the hydraulic system after it has been correctly connected. The hydraulic system can be gravity bled, manually
bled or bled with pressure bleeding equipment.
1. Fill the brake master cylinder reservoir with clean, specified brake fluid.
2. Connect a clear hose to the RH rear disc brake caliper bleeder screw and place the other end into a container partially filled with clean, specified
brake fluid.
