Mark LT 2WD V8-5.4L VIN 5 (2007)
7. Remove the 2 outer rear EVAP canister assembly bracket bolts.
-
To install, tighten to 20 Nm (15 lb-ft).
8. Remove the 2 inner rear EVAP canister assembly bracket bolts.
-
To install, tighten to 13 Nm (10 lb-ft).
9. Lower the EVAP canister assembly down slightly to disconnect the EVAP canister vent solenoid electrical connector and remove the EVAP
canister vent solenoid harness pushpin retainer.
10. Remove the EVAP canister assembly.
11. Remove the EVAP canister heat shield.
12. Disconnect the EVAP filter-to-EVAP canister hose.
13. Remove the EVAP canister from the EVAP assembly.
14. To install, reverse the removal procedure.
