Mark LT 2WD V8-5.4L VIN 5 (2007)
1. CAUTION: Inspect the seat cushion foam pad and seat cushion trim cover for any foreign objects before installing the seat cushion trim
cover to the seat cushion foam pad. If any foreign objects are found, remove them. Failure to do so may result in personal injury in the
event of an air bag deployment.
Install the seat cushion trim cover.
-
Install hog rings to attach the seat cushion trim cover to the seat cushion foam pad of the OCS assembly at all locations from where they were
removed.
2. At the front outboard side of the seat cushion frame, attach the 2 clips.
3. Attach the seat cushion trim cover J-clips to the seat cushion frame.
-
Do not attach the RH rear J-clip at this time, so as to route the belt tension sensor wire harness between the trim cover and seat cushion frame
later in the procedure.
-
If equipped, do not attach the LH rear J-clip at this time so as to route the lumbar cable between the trim cover and seat cushion frame later in
the procedure.
4. NOTE: Make sure the trim cover J-clips (left unattached for purposes of routing the belt tension sensor wire harness or lumbar cable) are
accessible after the seat cushion assembly has been positioned to the seat track.
Install the seat cushion assembly to the seat track.
-
Position the safety belt buckle through the seat cushion strap.
-
Tighten to 25 Nm (18 lb-ft).
5. If equipped, connect the backrest heated seat element electrical connector and attach any wire harness retainers to the seat cushion frame.
6. If equipped, connect the power seat motor electrical connector and attach any wire harness retainers to the seat cushion frame.
7. NOTE: If equipped with manual lumbar, make sure this wire harness is routed above the manual lumbar cable.
