Mark LT 2WD V8-5.4L VIN 5 (2007)
Seals and Gaskets: Service and Repair
Extension Housing Gasket
Extension Housing Gasket
Material
Removal
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
Rear wheel drive (RWD) vehicles
2. NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original positions.
Mark the driveshaft flange and the rear pinion flange for correct alignment during assembly.
3. Remove the 4 rear driveshaft bolts.
Four wheel drive (4WD) vehicles
4. Remove the transfer case.
All vehicles
5. Using a suitable high-lift jack, support the transmission.
6. Remove the 2 bolts from the exhaust hanger.