Mark LT 2WD V8-5.4L VIN 5 (2007)
6. Disconnect the transmission selector lever electrical connector and remove the selector lever from the vehicle.
Installation
1. Position the transmission selector lever assembly in the console and install the bolts.
^
Tighten to 12 Nm (9 ft. lbs.).
2. Connect the transmission selector lever harness electrical connector.
3. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever
cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull
back on the selector lever cable end to make sure that the cable end is correctly installed.
Install the transmission selector lever cable in the transmission selector lever cable bracket.