Mark LT 2WD V8-5.4L VIN 5 (2007)
Removal
CAUTION: This operation disturbs the pinion bearing preload. Carefully reset the pinion bearing preload during assembly.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: The front wheels and tires and brake calipers must be removed to prevent drag during the pinion bearing preload recording and
adjustment.
Remove the front tires and wheels.
3. Remove the front driveshaft.
4. CAUTION: When removing the disc brake caliper, never allow it to hang from the brake hose. Provide a suitable support.
Remove the disc brake caliper anchor bolts, then remove the disc brake caliper and disc brake caliper anchor as an assembly.
^
Using mechanic's wire, position and support the disc brake caliper and disc brake caliper anchor.
5. Measure and record the pinion bearing preload.
^
Using a Nm (inch lbs.) torque wrench, rotate the pinion gear. Measure the torque required to maintain pinion gear rotation.
