Mark LT 2WD V8-5.4L VIN 5 (2007)
Drive/Propeller Shaft: Service and Repair
Disassembly and Assembly
Driveshaft Universal Joint - Snap Ring Type
Special Tools
Material
Disassembly
1. Remove the driveshaft.
2. CAUTION: Do not, under any circumstance, clamp the driveshaft assembly in the jaws of a vise or similar holding fixture. Denting or localized
fracturing may result, causing driveshaft failure during vehicle operation.
Place the driveshaft on a suitable workbench. Do not damage the tube.
3. NOTE: If the components are not marked and therefore installed incorrectly, driveshaft imbalance can occur.
Index-mark, the driveshaft components.
4. Remove and discard all 4 of the snap rings.
