Mark LT 2WD V8-5.4L VIN 5 (2007)
5. Place the special tool in a vise.
6. NOTE: If necessary, use a pair of pliers to remove a bearing cup that fails to press out all the way.
Remove the bearing cups and the driveshaft slip yoke.
1. Position the driveshaft slip yoke in the special tool.
2. Press out a bearing cup.
3. Rotate the driveshaft slip yoke 180 degrees.
4. Press on the U-joint spider to remove the remaining bearing cup.
5. Remove the driveshaft slip yoke.
7. Repeat steps to remove the remaining bearing cups and the U-joint spider from the driveshaft yoke.
8. NOTE: Inspect the bearing cup bores and retaining ring grooves. Remove any rust or other surface irregularities.
