Mark LT 4WD V8-5.4L VIN 5 (2006)
Front Door Exterior Handle: Service and Repair
Door Handle
EXTERIOR FRONT DOOR HANDLE
Removal and Installation
1. Remove the front door trim panel.
2. Position the watershield aside.
3. If equipped, release the lock cylinder actuating rod.
4. Open the clip and disconnect the exterior front door handle actuating rod from the front door latch.
5. Remove the 2 exterior front door handle nuts.
-
To install, tighten to 7 Nm (62 lb-in).
6. If equipped, disconnect the remote keyless entry (RKE) keypad electrical connector and disconnect the harness channel from the door.
7. Remove the 2 exterior front door handle nut seals.
8. Remove the 2 bolts and the exterior front door handle.
9. To install, reverse the removal procedure.