Mark LT 4WD V8-5.4L VIN 5 (2006)
Seat Track: Service and Repair
Seat Track - Power
SEAT TRACK - POWER
Worldwide Diagnostic System (WDS)
Special Tool(s)
Removal and Installation
WARNING:
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
could result in pretensioner or air bag deployment and could result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
-
If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the seat and depower the SRS.
2. Remove the front seat backrest.
Regular cab and SuperCab seats
3. Remove the 6 front seat frame rear support bolts and the support.
-
When installing, install the bolts and torque in the sequence shown.
-
To install, tighten to 30 Nm (22 lb-ft).
Driver seat
4. Remove the 2 seat track position sensor bracket nuts and sensor.
All seats
5. To install, reverse the removal procedure.
6. Install the seat and repower the SRS. Do not prove out the system at this time.
Passenger seat
