Mark LT 4WD V8-5.4L VIN 5 (2006)
Hydraulic Brake Actuation - Exploded View
1. Disconnect the battery.
2. Using a suitable suction device, drain the brake fluid reservoir.
3. Disconnect the brake fluid level switch electrical connector.
4. NOTE: Cap the brake lines and plug the master cylinder ports.
Disconnect the 2 brake lines from the master cylinder.
^
To install, tighten to 17 Nm (13 ft. lbs.).
5. Remove the 2 master cylinder nuts.
^
To install, tighten 25 Nm (18 ft. lbs.).
6. To install, reverse the removal procedure.
^
Bleed the brake system.
