Mark LT 4WD V8-5.4L VIN 5 (2006)
Oil Temperature Sensor For ECM: Service and Repair
OIL TEMPERATURE SENSOR
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the oil drain plug and drain the engine oil.
-
To install, tighten to 14 Nm (10 lb-ft).
4. Disconnect the oil temperature sensor electrical connector.
5. Remove the oil temperature sensor.
-
To install, tighten to 21 Nm (15 lb-ft).
6. To install, reverse the removal procedure.
