Mark LT 4WD V8-5.4L VIN 5 (2006)
Removal and Installation
Both sides
1. Disconnect the battery ground cable.
LH side
2. Remove the power steering fluid reservoir support bracket nut.
-
To install, tighten to 10 Nm (89 lb-in).
3. Remove the bolts and position the power steering fluid reservoir support bracket and reservoir assembly aside.
-
To install, tighten to 25 Nm (18 lb-ft).
Both sides
4. Disconnect the variable camshaft timing (VCT) oil control solenoid electrical connector.
5. Remove the grommet.
6. Remove the bolt and the VCT oil control solenoid.
-
To install, tighten to 5 Nm (44 lb-in).
7. To install, reverse the removal procedure.