Mark LT 4WD V8-5.4L VIN 5 (2006)
7. Remove the 2 outer rear EVAP canister assembly bracket bolts.
-
To install, tighten to 20 Nm (15 lb-ft).
8. Remove the 2 inner rear EVAP canister assembly bracket bolts.
-
To install, tighten to 13 Nm (10 lb-ft).
9. Lower the EVAP canister assembly down slightly to disconnect the EVAP canister vent solenoid electrical connector and remove the EVAP
canister vent solenoid harness pushpin retainer.
10. Remove the EVAP canister assembly.
11. Disconnect the EVAP canister vent solenoid fuel vapor tube from the dust separator.
12. Release the clips and remove the dust separator from the EVAP canister assembly.
13. To install, reverse the removal procedure.
