Mark LT 4WD V8-5.4L VIN 5 (2006)
4. Disconnect the quick connect fitting.
-
Push the fitting toward the tube to release pressure.
-
Press the tab corners to release the fitting.
-
Disconnect the quick connect fitting.
Connect - Type I
1. NOTE:
-
If the fuel tube retainer clip is broken or damaged, install a new clip using a suitable fuel line disconnect tool to separate the retaining clip legs.
Once the retainer legs have been separated, lift the clip out of the connector housing, lifting from the stamped side of the connector body.
-
Apply clean engine oil to the end of the tube or fitting before connecting.
Connect the tube into the quick connect fitting.
2. CAUTION: Make sure the quick release fitting clicks into place when installing the tube. To make sure that the quick release fitting is
fully seated, pull on the fitting.
Press the locking tab down into the LOCKED position.
Disconnect - Type II
WARNING:
-
The evaporative emissions system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still presents
the danger of explosion or fire. Disconnect the battery ground cable from the battery to minimize the possibility of an electrical spark
occurring, possibly causing a fire or explosion if fuel vapor or liquid fuel are present in the area. Failure to follow these instructions may
result in personal injury.
-
Do not smoke or carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
