Mark LT 4WD V8-5.4L VIN 5 (2006)
Body Control Module: Service and Repair
Driver Seat Module (DSM)
DRIVER SEAT MODULE (DSM)
Removal and Installation
CAUTION: Prior to the removal of the DSM, it is necessary to upload the module configuration information to the diagnostic tool. This information
needs to be downloaded into the new module once installed.
1. Remove the driver seat.
2. Remove the 2 DSM screws.
-
To install, tighten to 7 Nm (62 lb-in).
3. Disconnect the 4 DSM electrical connectors and remove the DSM.