Mark LT 4WD V8-5.4L VIN 5 (2006)
3
Turn the clockspring clockwise approximately 3 turns. This is the center point of the clockspring.
-
Do not allow the rotor to turn from this position. To prevent accidental rotation until the clockspring is installed, 2 pieces of tape may be
applied to the clockspring.
2. NOTE: Slight turning of the clockspring rotor is allowable for alignment purposes to the steering column.
With the flats of the clockspring aligned to the flats of the steering column, slide the clockspring onto the steering column.
-
For vehicles receiving a new clockspring, remove the retaining pin.
-
For vehicles reusing the clockspring that was removed, remove the tape.
3. Connect the clockspring electrical connectors.
-
Make sure to align and completely seat the electrical connectors.
4. Install the multi-function switch and screw.
5. Install the upper steering column shroud and shroud screw.
6. Install the lower steering column shroud and screw.
7. Install the steering wheel.
8. Install the driver air bag module.
9. Repower the system.
