Mark LT 4WD V8-5.4L VIN 5 (2006)
5. Remove the C-pillar trim panel(s) and position aside.
6. Remove the safety belt retractor bolt and the safety belt retractor.
-
To install, tighten to 48 Nm (35 lb-ft).
7. To install, reverse the removal procedure.
8. Check the active restraint system for correct operation.
Safety Belt Retractor - Rear, Center
SAFETY BELT RETRACTOR - REAR, CENTER
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor [BTS] if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
1. Remove the rear seat backrest.
2. Remove the bolt and the D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the back of the cab panel insulator.
-
Remove the pin-type retainers.
-
Release the retaining clips and remove the panel insulator.
