Mark LT 4WD V8-5.4L VIN 5 (2006)
5. If equipped with lumbar, release the J-clip and route out the lumbar cable.
6. NOTE: Disconnect and release any remaining electrical connectors and pin-type retainers necessary to remove the seat cushion frame.
Remove the seat cushion frame assembly.
-
To aid in removal, recline the seat.
-
Remove the safety belt buckle from the seat cushion strap.
7. Release the seat cushion trim cover J-clips from the seat cushion frame.
8. At the front outboard side of the seat cushion frame, pull the trim cover back and release the 2 remaining clips.
9. Remove all the hog rings and separate the trim cover from the foam pad of the OCS assembly.
Installation
CAUTION:
-
While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the components.
Failure to do so can result in component failure.
-
It is necessary to rezero the occupant classification sensor (OCS) system when a front passenger seat cushion is disassembled, a new trim
cover installed or an OCS service kit is installed. A diagnostic tool is used to trigger the active command to carry out rezeroing of the
OCS system.
NOTE: Occupant classification sensor (OCS) system components (seat cushion frame, seat cushion foam pad, bladder with pressure sensor, seat wiring
harness and electronic control unit) are calibrated to each other and are serviced as an assembly. The OCS system components are not to be installed
separately. If a new OCS system, OCS system component or cushion foam pad are needed, a new OCS system service kit (seat cushion frame, seat
