Mark LT 4WD V8-5.4L VIN 5 (2006)
4. Using the special tool, separate the outer tie-rod end from the wheel knuckle.
5. NOTE: Note the number of times the outer tie-rod ends turn for reference during assembly.
Remove the outer tie-rod end.
6. Remove the outer tie-rod end lock nut from the inner tie-rod.
7. Remove the outer boot clamp.
8. Remove and discard the inner boot clamp.
9. CAUTION: If present, the orientation of the vent tube must be noted so the boots and vent tubes can be installed in the correct location.
Remove the steering gear boot.
10. If removing the RH inner tie-rod, position the LH outer boot clamp from the LH steering gear boot.
11. If removing the RH inner tie-rod, remove and discard the inner boot clamp and position the LH steering gear boot aside to gain access to the rack
gear.
12. CAUTION: Place the steering gear at the center position. Use a 15/16 inch crowfoot on the flat of the rack gear to resist rotation and to prevent
damage during the removal of the inner tie-rod.
NOTE: An assistant may be needed for removal of the RH inner tie-rod.
Using the special tool, remove the inner tie-rod.
Installation
1. CAUTION: Thoroughly remove any abrasive material. This material is extremely harmful to the steering gear.
Thoroughly clean and inspect all parts to be reused. Replace any parts as necessary.
