Mark LT 4WD V8-5.4L VIN 5 (2006)
3. Remove the reverse band servo spring.
Installation
NOTE: This is not an ordinary installation procedure and does not compensate for band wear.
1. NOTE: Lubricate the reverse piston seal to facilitate assembly and prevent damage to the seal.
Install the reverse servo return spring and piston.
^
Do not install the piston cover.
2. Install the special tool and tighten the band apply bolt.
^
Tighten to 5.6 Nm (50 inch lbs.).
3. Attach the special tool to the transmission.
Position the indicator stem on the flat portion of the reverse servo piston and zero the dial indicator.
