Mark LT 4WD V8-5.4L VIN 5 (2006)
3. Remove and discard the wheel end nut.
^
To install, tighten to 27 Nm (20 ft. lbs.).
4. Remove the vacuum and vent line at the vacuum and vent port of the integrated wheel end.
5. Remove the 3 integrated wheel end bolts.
^
To install, tighten to 12 Nm (9 ft. lbs.).
6. Remove the tie-rod nut and separate the tie rod from the knuckle.
^
Discard the tie-rod nut.
^
To install, tighten to 150 Nm (111 ft. lbs.).
