Mark LT 4WD V8-5.4L VIN 5 (2006)
11. CAUTION: Do not damage the hub seal.
Separate the halfshaft from the axle and remove the halfshaft from the vehicle.
12. CAUTION: Do not install the integrated wheel end in the knuckle. It must be installed on the outer constant velocity joint housing.
CAUTION: Do not dislodge the integrated wheel end seal spring when installing the integrated wheel end on the outer constant velocity joint
housing.
NOTE: Compress the integrated wheel end and install a vacuum cap on the vacuum port.
To install, reverse the removal procedure.
^
Install the following new fasteners:
-
Wheel end nut, tighten to 27 Nm (20 ft. lbs.)
-
Tie-rod nut 150 Nm (111 ft. lbs.).
-
Upper ball joint nut 150 Nm (111 ft. lbs.).
