Mark LT 4WD V8-5.4L VIN 5 (2006)
7. NOTE: LH side shown, RH side similar.
Slowly release the clamp on the cable to gradually unload the tension spring on the motor housing.
8. NOTE: LH side shown, RH side similar.
Remove the cable swag from the guide bracket on the sliding rear window.
9. Disconnect the rear window glass motor electrical connector.
10. Remove the rear window glass regulator and motor assembly screws.
11. Remove the rear window glass regulator and motor assembly from the vehicle.
Installation
1. Install the rear window glass regulator and motor assembly to the vehicle.
2. Install the rear window glass regulator and motor assembly screws.
-
Tighten to 11 Nm (8 lb-ft).
3. Connect the rear window glass motor electrical connector.
4. CAUTION: The following substeps are to prevent the cables from popping out of the motor housing. If an existing regulator and motor
assembly is to be reused, do not allow the cables to pop out of the motor housing, as they can unwind from the drum. If the cables unwind
from the drum, a new regulator and motor assembly will have to be installed.
NOTE: LH side shown, RH side similar.
Install the LH cable first, then the RH cable. Install the cable swag into the guide bracket on the sliding rear window.
