Mark VII V8-302 5.0L (1984)
19.
Disconnect the harness connectors from the blower motor wires and the blower motor speed controller (Figure 6).
20.
Disconect the EATC sensor hose and elbow from the evaporator case (Figure 6).
21.
Disconnect the EATC harness at the control assembly
22.
Disconnect the antenna cable from the radio and from the strap retaining the cable to the evaporator case.
FIGURE 11
23.
Using a sharp knife, carefully slit the carpet on the top of the transmission tunnel as shown in Figure 11. Then, fold the carpet back to expose the
rear seat heater duct.
