Mark VII V8-302 5.0L HO (1986)
Installation
1.
Clean exhaust manifold and catalytic converter flange seats.
2.
Align upper and lower heat shields to converter flange. Install and tighten retaining bolts to 14-20 N-m (11-14 Lb.Ft).
3.
Insert shield rods into front bracket insulators.
4.
Position inlet pipe to manifold and install. Do not tighten retaining nuts.
5.
Remove wire support from muffler assembly and install muffler inlet flange to converter outlet flange. Loosely install retaining nuts.
6.
Align exhaust system to proper clearance specifications, as shown in View A of illustration.
7.
Starting at the front of the system, tighten all nuts and bolts to the specifications shown.
8.
Connect downstream air injection hose at check valve, if so equipped.
9.
Check exhaust system for leaks.
