Mark VII V8-302 5.0L VIN F FI (1987)
a.
Route the cable down the left hand side of the vehicle from the radio to the antenna, beneath the carpeting. The original cable may have been
routed down the right side of the vehicle.
b.
Secure cable with tape as needed to prevent possible rattles.
6.
Apply grease (F2AZ-19584-A) to the outside of the installed antenna cable connector at the antenna. This will prevent water entry into the antenna
cable connector shell.
Noise In Tape Mode
G.
Noise In Tape Mode
1.
Ignition Noise in Tape Mode
2.
Alternator Whine in Tape Mode
DIAGNOSTICS:
Perform the following to verify noise concern.
1.
Ignition Noise in Tape Mode:
^
Engine running.
^
Vary the engine RPM.
^
Ignition noise is heard during quiet passages of tape or on a blank tape.
2.
Alternator Whine in Tape Mode:
^
Engine running.
^
Vary the engine RPM.
^
Alternator whine is heard during quiet passages of tape or on blank tape.
