Mark VII V8-302 5.0L VIN F FI (1987)
FIGURE 2 - Control Assembly Location
REMOVAL AND INSTALLATION
Control Assembly
Removal and Installation Refer to Fig. 2
1.
Remove knob from control lever.
2.
Remove applique.
3.
Remove screws retaining the climate control head to the instrument panel and remove the climate control head.
4.
Remove control assembly from the climate control head assembly.
5.
To install, reverse Steps 1 through 4.
Window Disconnect wire leads at each end of the glass (Fig. 3). Remove window. Refer to Section 43-11.
MAJOR SERVICE OPERATIONS
Grid Wire Repair
NOTE:
A single break or any breaks that total more than 25 mm (1 inch) in one grid cannot be repaired. The window must be replaced. For breaks
less than 25 mm (1 inch) long, use the following procedure:
Mark VII - Thunderbird/Cougar - Mustang