Mark VIII V8-4.6L DOHC (1996)
2. Place slider pins and boots on anchor plate, then position caliper assembly on anchor plate. Inspect to be sure brake pads and anti-rattle springs are
properly positioned.
3. Apply suitable sealer and thread locking compound to pinch bolt threads, then install pinch bolts.
4. Using open end wrench to hold slider pin in position, tighten pinch bolts.
5. Attach parking brake cable to lever arm, then install retaining clip.
6. Using replacement washers, connect brake hose to caliper.
7. Perform system brake bleeding procedures, then install wheel and tire assembly.
8. Cycle brake pedal several times to position brake pads and caliper piston.