Mark VIII V8-4.6L DOHC (1996)
Brake Pad: Service and Repair
Rear
REMOVAL
CAUTION: On models with air suspension, turn service switch OFF before beginning repairs, then turn ON after completing service.
1. Raise and support rear of vehicle, then remove wheel and tire assembly.
2. Remove brake hose bracket to shock unit bracket screw.
3. Remove retaining clip, then disconnect parking brake cable from lever.
4. Using open end wrench to hold slider pin in position, remove upper pinch bolt. Loosen, but do not lower, slider pin pinch bolt.
5. Carefully rotate caliper away from rotor, then remover inner and outer brake pads and anti-rattle springs from anchor plate.
INSTALLATION
Fig. 14 Positioning Caliper Piston To Brake Pad Nib
