Mark VIII V8-4.6L DOHC (1996)
A. Position Rear Hub Remover between the rear wheel knuckle and the rear wheel disc brake shield.
B. Assemble Hub Remover/Replacer and Step Plate or equivalent.
C. With forcing nut below the crossbar, hold forcing screw and turn forcing nut to remove hub.
3. Remove the rear wheel disc brake shield.
4. Remove bearing retainer snap ring.
5. Place rear wheel knuckle and rear wheel bearing on a press bed using Hub Support and Bearing Remover, and press wheel bearing out of rear
wheel knuckle.
Installation
1. Place rear wheel knuckle assembly on press bed and position rear wheel bearing in the bearing bore of the rear wheel knuckle.
