Mark VIII V8-4.6L DOHC (1996)
6. Remove wiper module assembly.
7. Relieve fuel system pressure and disconnect fuel lines.
8. Release drive belt tensioner and remove drive belt.
9. Remove two retaining nuts from engine air cleaner outlet tube bracket and remove engine air cleaner outlet tube bracket.
10
Remove eight retaining nuts on RH and LH ignition wire covers and remove ignition wire covers.
CAUTION: Do not pull on ignition wire as it may separate from the connector in the ignition wire boot.
11. Disconnect ignition wires from spark plugs with a gentle twist and pull motion on the spark plug boot.
12. Disconnect ignition wires from ignition coils.
13. Detach two center ignition wire separators from generator mounting bracket.
14. Remove ignition wires.
15. Disconnect generator wiring harness from generator at battery positive terminal and disconnect stator connector plug. Disconnect wiring harness
retaining clip from generator mounting bracket.
16. Remove two bolts and two nuts attaching generator mounting bracket to generator and intake manifold. Remove generator mounting bracket.
17. Disconnect upper radiator hose and water bypass tube to thermostat hose at water bypass tube.
18. Disconnect engine control sensor wiring from both Engine Coolant Temperature (ECT) sensor and water temperature indicator sender unit
connectors at bottom of water bypass tube.
