Mark VIII V8-4.6L DOHC (1996)
Seat Belt: Service and Repair
Service Procedures
Repair Notes
NOTE: The lap/shoulder safety belts are factory installed in their proper locations. If the belts are removed for any reason, they should be installed as
shown in Removal and Installation. The 7/16 x 20 Torx(R) head anchor bolts must be hand started and then tightened to 30-40 N.m (22-30 lb-ft).
Safety Belt Tongue Rotated on Belt
1. Grasp belt tongue and pull down on belt webbing to form a loop through the upper (narrow and longer) slot in the tongue.
2. Working within the upper slot, rotate and fold belt webbing over itself as required to remove the twist.
3. Pull the excess belt webbing back through the upper slot in the tongue.
4. Repeat Steps 1, 2 and 3 to complete the removal of the twist at the lower (wider and larger) slot in the tongue.
