Mark VIII V8-4.6L DOHC (1996)
Air Dryer: Service and Repair
AIR COMPRESSOR/DRIER ASSEMBLY
1. Remove front bumper cover.
2. Remove fuel system carbon canister.
3. Disconnect compressor motor electrical connector.
4. Disconnect solid state relay connector.
5. Disconnect four air lines from compressor drier.
6. Disconnect wire harness and front left air line clip from rear face of compressor bracket.
7. Remove two lower screws attaching bracket to body.
8. Remove upper screw attaching top of compressor bracket to body.
9. Remove compressor/drier assembly from vehicle.
10. Reverse procedure to install.
