MKS AWD V6-3.7L (2009)
20. Position the headliner all the way rearward.
21. Lower the front of the headliner to floor and position all the way forward.
22. Rotate the headliner until partially out of the RH front door.
23. Position the headliner to be removed out of the longest angle of the driver side rear door.
24. NOTICE: Make sure to roll the edges of the headliner while removing. Failure to follow this direction may result in damage to the
headliner.
Remove the headliner from the vehicle.
25. NOTE: Obtain the 3M Duramix 4747 Super Fast Adhesive commercially. The 3M Duramix 4747 Super Fast Adhesive is a 2-part adhesive in a
50-ml dual-tube applicator. Depending on the size of the headliner and optional wire harness(es), the purchase of two to five 50-ml tubes is
suggested.
If installing a NEW headliner, transfer the wire harness in the following sequence:
1. Using a suitable marking tool, mark the new headliner with the routing and exit points of the wire harness from the original headliner.
2. Carefully remove the wire harness from the original headliner.
