MKS AWD V6-3.7L (2009)
Keyless Entry Transmitter: Testing and Inspection
Remote Keyless Entry (RKE) Transmitter Programming
Remote Keyless Entry (RKE) Transmitter Programming
NOTE: The Remote Keyless Entry (RKE) transmitter of the Intelligent Access (IA) key or Integrated Keyhead Transmitter (IKT) is programmed
automatically during the Passive Anti-Theft System (PATS) programming. For information on programming the IA or IKT keys, refer to the appropriate
key programming procedure depending upon vehicle equipment in Antitheft and Alarm Systems. This procedure is only for programming
conventional keyfobs to IKT-equipped vehicles.
NOTE: All RKE transmitters must be programmed at the same time.
NOTE: Do not apply the brake pedal during this sequencing, as doing so ends the sequence and the transmitters will not be programmed.
1. Electronically unlock the door locks using the door lock control switch.
2. Cycle the ignition switch from the OFF to the RUN position 8 times in rapid succession (within 10 seconds), with the eighth turn ending in RUN.
If the module successfully enters program mode, it locks and then unlocks all the doors.
3. NOTE: If no action is taken within 20 seconds after a transmitter has been programmed, the programming sequence ends (the doors lock and
unlock to confirm that programming is complete).
Within 20 seconds, press any button on the RKE transmitter to be programmed. The doors lock and then unlock to confirm that each RKE
transmitter is programmed. Repeat this step for each RKE transmitter.
4. Exiting the programming mode is accomplished if one of the following occurs:
-
The key transitions to the OFF position.
-
Twenty seconds have passed since entering programming mode or since the last RKE transmitter was programmed.
-
The maximum number (4) of RKE transmitters have been programmed.
5. Check the operation of the transmitter. If the door locks do not respond for the programmed RKE transmitter(s), wait several seconds and press the
button again. If the door locks still fail to respond, refer to Locks, Latches and Entry Systems - Integrated Keyhead Transmitter (IKT) See: Power
Locks/Testing and Inspection. (Make sure that no more than the maximum number of RKE transmitters are attempted to be programmed.)
