MKS AWD V6-3.7L (2009)
1. Switch the ignition to the OFF mode and close all vehicle doors.
2. Enter the permanent factory set 5-digit keyless entry keypad code.
3. Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press and release the 7/8 button. While still holding the 3/4 button,
press and release the 7/8 button a second time.
4. Release the 3/4 button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.
Programming the Auto-Unlock Feature Using the Instrument Panel Cluster (IPC) Message Center
NOTE: The auto-unlock feature can be activated or deactivated independently of the autolock feature.
NOTE: The auto-unlock feature can also be configured on or off with the scan tool. For additional information on module configuration, refer to
Information Bus.
1. Press the SETUP button on the message center switch until AUTOUNLOCK [ON] OFF is displayed.
2. Press the RESET button to select ON or OFF. If auto-unlock is enabled, the message center will have brackets around the [ON] display. If
auto-unlock is disabled, the message center will have brackets around the [OFF] display.
Remote Memory Activation
Remote Memory Activation
1. Position the driver seat and exterior mirror to the desired positions.
2. Press and hold either memory button (1 or 2) for 5 seconds. A tone will be heard after 1-1/2 seconds when the memory store is done. Continue to
hold until a second tone is heard after 5 seconds.
3. Within 3 seconds, press the LOCK button on the Remote Keyless Entry (RKE) transmitter.
4. If a second memory setting is desired, repeat the procedure with the second RKE transmitter.
Remote Memory Deactivation
Remote Memory Deactivation
1. Press and hold either memory button (1 or 2) for 5 seconds. A tone will be heard after 1-1/2 seconds when the memory store is done. Continue to
hold until a second tone is heard after 5 seconds.
2. Within 3 seconds, press the UNLOCK button on the Remote Keyless Entry (RKE) transmitter.
3. If a second memory setting is desired to be deactivated, repeat the procedure with the second RKE transmitter.
Perimeter Lighting Feature Programming
Perimeter Lighting Feature Programming
Programming the Perimeter Lighting Feature Using the Door Lock Control Switch
NOTE: The following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait
30 seconds between programming sessions.
1. NOTE: Prior to beginning, make sure the ignition is in the OFF mode and all vehicle doors are closed.
Switch the ignition from the OFF to the RUN mode.
2. Press the unlock button on the door lock control switch 3 times.
3. Switch the ignition from the RUN to the OFF mode.
4. Press the unlock button on the door lock control switch 3 times.
