MKS AWD V6-3.7L (2009)
6. NOTE: Outboard shown, inboard similar.
Release the backrest trim cover hook-and-loop strips and J-clip attached to the recliner.
-
Repeat for the other side.
7. Disengage the backrest trim cover J-clips attached to the backrest frame wires at the top.
8. Remove the backrest Thermo-Electric Device (TED).
1. Disconnect the electrical connector and separate the pin-type retainer from the backrest frame.
2. Disengage the backrest TED from the backrest foam pad wire.
3. Disengage the backrest TED from the backrest frame wire and remove the backrest TED.
9. Release all the backrest trim cover J-clips attached to the backrest frame.
10. Remove the backrest trim cover from the backrest foam pad.
-
Inside out the backrest trim cover and remove all the hog rings.
Installation
1. Inside out the backrest trim cover. Position the backrest trim cover to the backrest foam pad. Install 5 hog rings on the wire running across the top
of the backrest trim cover, attaching it to the backrest foam pad wire in the approximate locations shown.
