MKS AWD V6-3.7L (2009)
1. Remove the scrivet at the back of the cushion side shield.
2. Remove the screw at the front of the cushion side shield.
3. Pull out to release the clips and remove the cushion side shield.
-
Disconnect the seat control switch electrical connectors and separate the wire harness pin-type retainer.
-
At installation, return all retaining clips back to the cushion side shield before installing the shield.
6. Release the cushion trim cover from the back of the outboard recliner.
7. Release the cushion trim cover J-clips attached to the cushion frame.
8. Remove the cushion trim cover and cushion foam pad assembly.
9. NOTE: One side shown, other side similar.
Inside out the cushion trim cover, remove the 4 hog rings on both of the wires running the length of the cushion trim cover detaching it from the
cushion foam pad wires.
10. Remove the 3 hog rings on the wire running the width of the cushion trim cover detaching it to the cushion foam pad wire. Separate the cushion
trim cover from the cushion foam pad.
11. To install, reverse the removal procedure.