MKS AWD V6-3.7L (2009)
-
For passenger seat, disconnect the Belt Tension Sensor (BTS) electrical connector, remove the safety belt anchor bolt and separate the safety
belt anchor from the seat.
6. NOTE: For retainer clarity, inside of cushion side shield shown.
Remove the cushion side shield.
1. Remove the scrivet at the back of the cushion side shield.
2. Remove the screw at the front of the cushion side shield.
3. Pull out to release the clips and remove the cushion side shield.
-
Disconnect the seat control switch electrical connectors and separate the wire harness pin-type retainer.
7. Release the cushion trim cover from the back of the outboard recliner.
8. Release the cushion trim cover front and outboard side J-clip retainers from the cushion frame and position the cushion trim cover and cushion
foam pad up.
9. Remove the cushion TED.
1. Disconnect the electrical connector.
2. Remove the screw.
3. Disengage and remove the TED from the cushion support wires.
4. Disengage and remove the TED bracket from the cushion support wires.
Installation
All seats
1. Install the cushion TED in the following sequence.
1. Engage the TED bracket to the cushion support wires.
2. Position the TED and engage the cushion support wires.
