MKS AWD V6-3.7L (2009)
Seat Cushion Heater Mat - Rear
Removal
NOTE: Always install a new cushion foam pad and cushion heater mats together.
1. Remove the rear seat cushion. For additional information, refer to Seat Cushion - Rear See: Seat Cushion/Service and Repair/Rear Seats/Seat
Cushion - Rear.
2. Remove the rear seat cushion trim cover. For additional information, refer to Seat Cushion Cover - Rear See: Seat Cushion/Service and
Repair/Rear Seats/Seat Cushion Cover - Rear.
3. Obtain a new cushion foam pad and a new LH and RH cushion heater mat.
-
Do not remove the old backrest heater mats from the old backrest foam pad and reuse any of these parts.
Installation
NOTE: Always install a new cushion foam pad and cushion heater mats together.
1. NOTE: The cushion heater mat with the long wire harness goes on the RH side.
Install new cushion heater mats onto the new cushion foam pad.
1. Position a cushion heater mat onto the cushion foam pad so the opening aligns to the hook-and-loop strip in the cushion foam pad.
2. Tuck the cushion heater mat into the cushion foam pad trenches.
3. Make sure the cushion heater mat stays in place. Remove the paper strips from under the cushion heater mat and adhere to the cushion foam
pad, laying it flat with no wrinkles.
4. Route the cushion heater mat wire harness and electrical connector through the cushion foam pad to the other side.
2. From underneath the cushion foam pad, route the RH cushion heater mat wire harness into the cushion foam pad trench and out the other side.
Attach the wire harness retainer and connect the LH cushion heater mat electrical connector to the RH cushion heater mat electrical connector.
3. Install the rear seat cushion trim cover. For additional information, refer to Seat Cushion Cover - Rear See: Seat Cushion/Service and Repair/Rear
Seats/Seat Cushion Cover - Rear.
4. Install the rear seat cushion. For additional information, refer to Seat Cushion - Rear See: Seat Cushion/Service and Repair/Rear Seats/Seat
Cushion - Rear.
