MKS AWD V6-3.7L (2009)
Rear Door Window Glass Weatherstrip: Service and Repair
Door Glass Run Retainer - Rear
Door Glass Run Retainer - Rear
Removal and Installation
NOTE: The window motor must be de-initialized, then initialized whenever the window motor is removed from the window regulator drum housing, a
new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or lubricants are
applied to the window regulator or glass run.
1. Remove the rear door window glass. For additional information, refer to Window Glass - Rear Door See: Doors, Hood and Trunk/Doors/Rear
Door/Rear Door Window Glass/Service and Repair/Window Glass - Rear Door.
2. Remove the 2 door glass run retainer bolts.
-
To install, tighten to 8 Nm (71 lb-in).
3. Remove the glass run retainer through the large opening in the door.
4. To install, reverse the removal procedure.
-
De-initialize, then initialize the window regulator motor. For additional information, refer to Window Motor Initialization See: Windows and
Glass/Windows/Service and Repair.